Assa Abloy Norton 7500 Series Installation Instructions Manual

7500 Series
Note:
For Special Applications a separate door and frame preparation template is packed with these instructions.
Use this instruction sheet for installation sequence and closer adjustments only.
Left Hand Door - LH
Right Hand Reverse - RHR
Right Hand Door - RH
Left Hand Reverse - LHR
Right Hand Door - RH
Left Hand Reverse - LHR
Installation Instructions
damage or personal injury. These instructions
With or without suffix
With or without suffix
The closing force for series 7500 door closer is adjustable from a size 1 to a size 6, as outlined
in ANSI Standard A156.4. When this series of door closer is installed and adjusted to conform to
ADA reduced opening force requirements (5 lbs max.) for interior doors. It may not have adequate
closing force to reliably close and latch the door. Power adjustments charted on pages 3,4 and 5
are recommended where possible, to ensure proper door control.
Closer mounts on hinge (pull) side of door.
Closer mounts on frame face on opposite to hinge (push) side of door.
Closer mounts on opposite to hinge (push) side of door.
80-9377-1201-020 (06-11)
CAUTION
An incorrectly installed or improperly
adjusted door closer can cause property
should be followed to avoid the possibility
of misapplication or misadjustment.
"DA" (Delayed Action) closing.
"M" with metal Cover.
Regular Arm Installation
See Page 3.
Closer cover not shown
Top Jamb Installation
See Page 4.
Closer cover not shown
Parallel Arm Installation
See Page 5.
Closer cover not shown
Multi Size - 1 thru 6
Non Hold Open Door Closers
Models – 7500
Right Hand Door - RH
Left Hand Reverse - LHR
Left Hand Door - LH
Right Hand Reverse - RHR
Left Hand Door - LH
Right Hand Reverse - RHR
J7500
JL7500
P7500