Ricoh IM C6500 User Manual page 299

Message
"Programmed. Cannot
program the folder
destination(s) with
protection code(s)."
"SMTP authentication
email address and
administrator email
address mismatch."
"Some invalid
destination(s) contained.
Do you want to select
only valid
destination(s)?"
"The program is recalled.
Cannot recall the folder
destination(s) with
protection code(s)."
"The size of the scanned
data is too small. Check
the resolution and the
ratio and then press
[Start] again."
Cause
A destination specified
with a protection code is
included among the
programmed
destinations.
The SMTP
authentication e-mail
address is not registered
in the administrator e-
mail address.
The group contains an
e-mail address.
A folder destination
specified with a
protection code is
included among the
programmed
destinations.
The data scanned by
specifying [Scan Ratio]
[Specify Size] is too
small.
When a Message Appears While Using the Scanner Function
Solution and reference
• You cannot program a destination
specified with a protection code. Specify
this destination individually.
• To program this destination, cancel the
protection code and then register the
destination to a program.
See "Using the Protection Function to
Prevent the Misuse of Addresses", User
Guide (Full Version).
Register the SMTP authentication e-mail
address in [Settings] [System Settings]
[Send (Email/Folder)]
[Administrator's Email Address].
When sending data to a destination other than
an e-mail address, press [Select].
• You cannot recall a destination specified
with a protection code in a program.
Specify this destination individually.
• To program this destination, cancel the
protection code and then register the
destination to a program.
See "Using the Protection Function to
Prevent the Misuse of Addresses", User
Guide (Full Version).
• Increase [Send Settings]
• Specify a larger paper size in [Send
Settings] [Scan Ratio]
Size].
[Email]
[Resolution].
[Specify
297