Ricoh IM C6500 User Manual page 17
Hide thumbs
Also See for IM C6500:
- Operating instructions manual (20 pages) ,
- Operating instructions manual (124 pages) ,
- Operating instructions manual (24 pages)
Table of Contents
Advertisement
By default, the machine first switches to Low Power mode and then to Sleep mode after a lapse of time.
Fusing Unit Off Mode
In this mode, the main power indicator is lit. Because the heater of the fusing unit is turned off but
the screen of the control panel is still displayed, the power consumption decreases, but you can
start operation promptly. If you do not operate the machine for a specified period of time, the
machine emits a clicking sound and enters Fusing Unit Off mode.
• You can specify whether to enable the Fusing Unit Off mode and the time to wait before the
machine enters Fusing Unit Off mode under [Fusing Unit Off Mode (Energy Saving) On/Off].
See "Date/Time/Timer", User Guide (Full Version).
• In this mode, you can scan documents, send faxes, receive faxes into memory, change the
machine settings on the control panel, and perform other operations that do not require
printing.
Low Power Mode
In this mode, the control panel display turns off and the main power indicator remains lit. If the
machine is left idle for a specific time, it switches to Low Power mode.
• Low Power mode cannot be used if Fusing Off mode is enabled.
• You can change the amount of time that the machine waits before switching to Low Power
mode under [Low Power Mode Timer].
See "Date/Time/Timer", User Guide (Full Version).
• If you touch the control panel in Low Power mode, the machine exits the mode and the control
panel display turns on.
Sleep Mode
In this mode, the display of the control panel turns off and the main power indicator blinks slowly.
Power consumption is minimized. When you do not operate the machine for a specified period of
time or press [Energy Save] (
• You can specify the amount of time that the machine waits before entering Sleep mode under
[Sleep Mode Timer].
See "Date/Time/Timer", User Guide (Full Version).
• The machine recovers from Sleep mode when you perform one of the following:
• Lift the ADF.
• Place an original in the ADF.
• Touch the display of the control panel.
• Approach the machine and are detected by the human detection sensor.
See "Recovering from Sleep Mode When a Person Approaches the Machine", User
Guide (Full Version).
), the machine enters Sleep mode.
Turning On and Off the Power
15
Advertisement
Table of Contents
