Table of Contents
Advertisement
SC-T3100x Series
User's Guide
Settings item
Drying Time
Drying Time per
Pass
Drying Time per
Page
Auto Cut
Restore Default
Printing Language
USB
Network
Using the Menu
Settings value
*
0.0 to 10.0 seconds (0.0
)
*
0.0 to 60 minutes (0.0
)
*
On
Off
*
Auto
HP-GL/2
*
Auto
HP-GL/2
Explanation
Select the time the print head pauses to allow drying after each
pass. Choose from values between 0.0 and 10.0 seconds
Depending on the paper type, the ink may take a while to dry. If
the ink blurs on the paper, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
Specify how long the printer pauses to allow the ink to dry after
printing each page; choose from values between 0 and 60 minutes.
Depending on the ink density or paper type, the ink may take a
while to dry. If the ink blurs on the paper, set a longer time for
drying the ink. The longer the drying time, the more time required
for printing.
Select whether to automatically cut (On) or not cut (Off) using the
built-in cutter as each page is printed on roll paper. Set On to
automatically cut the edge if it is not a horizontal cut when paper is
loaded.
The setting selected with the printer driver takes priority when the
printer driver is used.
"Cutting the Roll Paper" on page 29
U
Restore the selected Custom Paper settings to default settings.
Normally, leave the setting as Auto. If HP-GL/2 or HP RTL print data
is sent from a CAD application or plotter, this is automatically
determined, and switched to HP-GL/2 mode.
If HP-GL/2 mode printing is not carried out normally, or if normally
printing in HP-GL/2 or HP RTL, set as HP-GL/2.
116
Advertisement
Table of Contents
