For Auto Sheet Feeder/Cut Sheet(1 Sheet) - Epson SC-T3100X Series User Manual

SC-T3100x Series User's Guide
E
Touch Paper Remaining.
F
Touch Setup.
The setting changes to On, and Remaining
Amount and Remaining Alert are enabled.
Touch each one and enter a value as follows.
❏ Remaining Amount: Total length of roll
paper (see the manual supplied with the roll
paper)
❏ Remaining Alert: Remaining amount value
that will be the timing for displaying the
remaining amount warning notification.
Note:
On the keypad screen for entering a numeric
value, enter numbers that include a number of
the first decimal place. For example, if you want
to enter 5 m, touch [5] and [0].
G
Touch at the top left of the screen to return
to the screen of step 5 and then touch OK.
You can start printing once Ready appears on
the screen.
Note:
If you replace the paper after the amount remaining
display shows 0 m or the paper has actually run out,
Remaining Amount returns to the manufacturer's
setting of 30m.
Loading and Setting the Paper
For Auto Sheet Feeder/Cut
Sheet(1 sheet)
Make the following settings after loading paper in the
Auto Sheet Feeder or after loading Cut Sheet(1 sheet).
Settings of Paper Type
This is the most important setting to obtain the
optimum print results. Not setting a paper type that
matches the loaded paper will cause wrinkles, scuffing,
uneven colors, and other trouble.
Settings of Paper Size
The paper size for paper loaded in the auto sheet
feeder or for Cut Sheet(1 sheet) is not detected
automatically. Set the size of the loaded paper.
How to Set
A
39
The currently set paper type is shown on the
screen displayed after loading cut sheet.
When changing Paper Type
Proceed to step 2.
When changing Paper Size without changing
Paper Type
Proceed to step 4.
When not changing either of them
Touch OK. You can start printing once Ready
appears on the screen.