Table of Contents
Advertisement
SC-T3100x Series
User's Guide
Settings item
Platen Gap
Top/Bottom Margins
Back Tension
Drying Time
Drying Time per Pass
Drying Time per Page
Auto Cut
Manage Remaining Amount
Using the Menu
Settings value
Explanation
1.6
This is displayed when Custom Paper is selected in Paper Type.
When registering Custom Paper, this is the Platen Gap (distance
2.1
between print head and paper) for the paper selected in Change
Reference Paper, so it does not normally need to be changed.
2.6
Change this to a setting that will widen the gap (a higher value) if
print results are smeared.
*
Setting this to Standard will set the top/bottom margins as follows
Standard
depending on the printer driver print targets.
Top 3 mm/Bottom
❏
CAD/Line Drawing: 3 mm/3 mm
3 mm
❏
Others: 30 mm/30 mm
Top 15 mm/
Bottom 15 mm
Left and right margins will remain at 3 mm regardless of settings. If
Top 45 mm/
there is any soiling on the top section of the print results, increase
Bottom 15 mm
the top margin.
"Printable area" on page 158
U
Auto
If there is any wrinkling on the paper during printing, set this to
High or Extra High.
Standard
High
Extra High
0.0 to 10.0
Select the time the print head pauses to allow drying after each
*
pass. Choose from values between 0.0 and 10.0 seconds.
seconds (0.0
)
Depending on the paper type, the ink may take a while to dry. If the
ink blurs on the paper, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
0.0 to 60 minutes
Specify how long the printer pauses to allow the ink to dry after
*
printing each page; choose from values between 0.0 and 60
(0.0
)
minutes. Depending on the ink density or paper type, the ink may
take a while to dry. If the ink blurs on the paper, set a longer time
for drying the ink. The longer the drying time, the more time
required for printing.
*
Select whether to automatically cut (On) or not cut (Off) using the
On
built-in cutter as each page is printed on roll paper. Set On to
automatically cut the edge if it is not a horizontal cut when paper is
Off
loaded. The setting selected with the printer driver takes priority
when the printer driver is used.
"Cutting the Roll Paper" on page 29
U
107
Advertisement
Table of Contents
