Epson SC-T3100X Series User Manual page 124

SC-T3100x Series User's Guide
General Settings - Network Settings
*Default setting
Settings item
Wi-Fi Setup
Router (Connect via Wi-Fi)
Wi-Fi Setup Wizard
Push Button Setup(WPS)
Others
PIN Code Setup(WPS)
Wi-Fi Auto Connect
Disable Wi-Fi
Using the Menu
Settings value Explanation
Disconnected or disabled
This is displayed in gray. Touch this, and on the next screen
touching Start Setup will display a Wi-Fi Setup Wizard menu,
performing a connection operation.
Connected
Touch to display the connection status and settings information.
Touch Change Settings to display Wi-Fi Setup Wizard and other
menus that allow you to switch the access point.
"Switching to Wireless LAN" on page 93
U
The list of SSIDs for the detected access points is displayed. From
the list, select the SSID to connect to, and connect.
If the access point to use supports WPS (Wi-Fi Protected Setup),
then this menu item can be used for connection. Input of SSID and
password is not required. After selecting this menu item, touch and
hold the push button on the access point until it flashes, then again
touch Start Setup on the printer screen to connect.
If the access point to use supports WPS (Wi-Fi Protected Setup),
then this menu item can be used for connection. Touch this to
display the PIN code and Start Setup. Input the displayed PIN code
from a computer into the access point within 2 minutes, then touch
Start Setup to connect.
The menu used after installing software from the Software Disc, and
connecting to the printer by following the wizard.
Selecting this means that the wireless LAN connection will be
initialized and disconnected. In the event of problems with the
wireless LAN connection, use this menu to reconnect and attempt
to resolve the problem.
124