Table of Contents
Advertisement
service
Fastening the seat belt
curely engaged.
Unfastening the seat belt
Settings
›
Grasp the buckle latch
and slowly pull the belt
over the chest and pel-
vis towards the buckle.
›
Insert the buckle latch
into the buckle until
there is an audible
click.
›
Carry out a tensile test
to determine whether
the lock tongue is se-
›
Grab the lock tongue
and release it by press-
ing the red button.
›
Hold the belt so it does
not twist when rolling
up.
›
Move the seat belt
height adjuster up-
wards to increase the
height.
›
Press the safety button
and move the seat belt
height adjuster down
to reduce the height.
›
After adjustment, firm-
ly pull on the belt to
ensure that the seat
belt height adjuster has
correctly locked in
place and that the belt
is locked securely.
Restraint systems and airbags ›
Troubleshooting
Blocked automatic belt retractor
locking procedure once or twice.
›
If the strap is still blocked, seek the help of a spe-
cialist garage.
Child seat
What you should be mindful of
For how to install and use the child seat, please note
the instructions in this Owner's Manual as well as the
instructions of the child seat manufacturer.
For safety reasons, we always recommend that chil-
dren are transported on the back seats. Carry chil-
dren on the front passenger seat only in exceptional
cases.
Child seats according to the standard ECE-R 44 of
the European Economic Commission.
Child seats according to standard ECE-R 44 are
marked with the test symbol: large E in a circle, with
the test number under it.
We recommend using child seats from the ŠKODA
Genuine Accessories range. These child seats have
been developed and tested for use in ŠKODA vehi-
cles. They comply with the standard ECE-R 44.
WARNING
When installing the child seat on the rear seat, ad-
▶
just the front seat so that there is no contact be-
tween the front seat and the child seat or the child
carried in the child seat.
Before installing a forward-facing child seat, adjust
▶
the headrest so that it is as low as possible.
If the headrest prevents the child seat from being
▶
fitted, adjust the headrest to the highest position.
When installing the child seat, avoid contact with
▶
the area of the roof and the rear pillar. There is a
risk of injury when the head airbag is deployed.
If using a separate child seat cushion, adjust the
▶
headrest so that the child's head is flush with, but
not protruding above the height of the top edge of
the headrest.
Child seat
33
›
Grasp the strap in the
middle and pull quickly
in the direction of the
arrow.
›
Hold the strap and let
it roll up slowly.
›
Pull on the strap to see
if the retractor is
working properly.
›
If the strap is still
blocked, repeat the un-
Advertisement
Table of Contents
