Table of Contents
Advertisement
44 Lighting, windscreen wipers and washers ›
Change bulb - Variant 1 (light with LED light sour-
ces)
curely connected.
›
Insert the bulb holder into the light and snap into
place.
NOTICE
Risk of damage to the electrical system!
Make sure that no cables are trapped when insert-
▶
ing the holder into the lamp.
Change bulb - Variant 2 (light only with light bulbs)
Replace light bulbs
›
Pull
some-
the lock A
what out of the plug.
›
Press the safety button
and pull out the plug.
›
Unlock and remove the
lamp holder
.
the lock A
›
Turn the defective light
bulb and take it out of
the holder.
›
Insert a new light bulb
into the socket and se-
cure the light bulb by
turning it in the direc-
tion of
.
›
Check that the con-
nector
is se-
the lock A
Change the bulb in the
outer part of the lamp.
›
Turn and remove the
socket with the bulb.
Insert and fix the lamp
›
Insert the connector into the light until it clicks into
place.
›
Press in the slightly pulled out latch on the connec-
tor.
›
Stick The lamp with the openings
in the body.
B
NOTICE
Risk of damage to the electrical system due to water
ingress!
Make sure that the seal is used correctly when in-
▶
stalling the lamp
.
C
›
Change the bulb in the
socket.
›
Push the base with the
new light bulb into the
luminaire so that the
guide lugs on the base
and the associated
openings in the lumin-
aire are flush.
›
Turn the socket clock-
wise
to secure.
Change the bulb in the
inner part of the lamp.
›
Unlock and remove the
lamp holder
.
A
›
Turn the defective light
bulb and take it out of
the holder.
›
Insert a new light bulb
into the socket and se-
cure the light bulb by
turning it in the direc-
tion of
.
›
Insert the bulb holder
into the light and snap
into place.
on the bolts
A
Advertisement
Table of Contents
