A Support Specifications - Huawei NetCol8000-A Series User Manual

NetCol8000-A(050, 100) In-room Air Cooled Smart
Cooling Product
User Manual
The EPDM rubber shock absorption bars with a thickness of 5 mm must be attached to the top
of the support.
Make supports by referring the following recommendations:
1.
2.
3.
4.
5.
Figure A-1
Issue 10 (2019-01-15)
A
Recommended to use angle steel, square steel or channel steel, and width is 45 mm,
thickness is 4-5 mm.
Dashed line on Figure A-1
you should avoid interfering with these when making the support.
a. When the width of angle steel is less than 45 mm or equal, do not consider
avoiding.
b. When the width of angle steel is more than 45 mm but less than 79.5 mm, it is
interfering with the holes which routing cables and the pipes, please cut out holes to
avoid interfering.
c. When the width of angle steel is more than 79.5 mm, it is interfering with the holes
which lowering fans, please cut out holes to avoid interfering.
It's width between support and cabinet fixing bolt hole is 55 mm, weld the bolts on
the "L"shape or other parts, and then weld them on the support when it is unable to cut
holes to weld the bolts on support directly.
Please note that to control the welding process and avoid excessive error.
Φ = 43 mm appeared in the above figures indicate the inside diameter with the rubber
ring.
and Figure A-2 show the support specifications.
Copyright © Huawei Technologies Co., Ltd.
Support Specifications
and Figure A-2 labeled indoor fan and bottom knockouts path,

A Support Specifications

178