Exporting Data - Huawei NetCol8000-A Series User Manual

NetCol8000-A(050, 100) In-room Air Cooled Smart
Cooling Product
User Manual
----End

5.7.3 Exporting Data

Context
Active alarms, historical alarms, logs, configurations, and run logs can be exported. The
export method for the five data is the same. This section uses how to exporting active alarms
as an example to explain the operation method.
You are advised to use the FAT32 USB flash drive with a capacity no greater than 64 GB.
Format the non-FAT32 USB flash drives into FAT32 ones before using them.
Before using a USB flash drive, ensure that its data has been scanned by antivirus software
and is secure.
Procedure
Step 1 On the home screen, choose Maint > USB Operations > Export Act. Alarms to enter the
Select Path screen, as shown in
Figure 5-37 Select path
Step 2 Tap the file where the user saves active alarms in the Select Path dialog box and tap Next.
Then tap Yes in the displayed dialog box shown in
screen shown in
Issue 10 (2019-01-15)
After logs are deleted, the log deletion operation is recorded in the first log that is displayed.
 Before exporting active alarms, historical alarms, logs, and configurations, ensure that the USB flash
drive has been successfully identified.
 If the USB flash drive has been successfully identified,
 If the USB flash drive is not properly connected, the system will notify that the USB flash drive is
not detected.
Figure 5-39.
Copyright © Huawei Technologies Co., Ltd.
Figure 5-37.
Figure
5 ACC Introduction
is displayed at the status bar.
5-38. Enter the Processing Info
118