How To Import A Certificate And Key - Huawei NetCol8000-A Series User Manual

NetCol8000-A(050, 100) In-room Air Cooled Smart
Cooling Product
User Manual

Procedure
Step 1 Check whether strong electromagnetic interference exists around the E-label identification
board.


Step 2 Disconnect the main power supply of the smart cooling product.
Step 3 Check whether the E-label identification board is properly connected.


Step 4 Check whether cables are properly connected.


Step 5 Reconnect the main power supply of the smart cooling product.
Step 6 If the fault persists, contact Huawei technical support.
----End

5.19 How to Import a Certificate and Key

Prerequisites
You have obtained CA certificate file, local certificate file, and key file into a USB disk.
Issue 10 (2019-01-15)
If the information shown in
cooling product cannot run properly. Perform
Figure 5-57 Message 2
In the Figure 5-57 the ACC V100R001C20SPC300 version is used as an example to describe the prompt
messages on the screen. During actual operations, the version in use prevails.
If yes, contact Huawei technical support.
If no, continue with Step
If no, reconnect the board properly and continue with
If yes, continue with Step
If yes, contact Huawei technical support to replace the E-label identification board.
If no, reconnect or replace cables and perform
Copyright © Huawei Technologies Co., Ltd.
Figure 5-57 is displayed on the controller LCD, the smart
Step 2
2.
4.
Step
5 ACC Introduction
to end.
Step 5.
5.
133