danalock V3 BT Manual

Simple Guidelines
Please follow these guidelines when configuring, using or
recycling the Danalock V3. Violating these guidelines may be
dangerous, illegal or otherwise detrimental. Further detailed
information is provided in this manual.
Terms of use
The Danalock Danalock V3 is designed for indoor use only. Use
only Danalock approved accessories for the Danalock V3. Do
not connect incompatible products, and do not operate the
Danalock V3 where wireless radio communication is prohibited.
Like hospitals, buildings near blasting sites etc.
Do Not Operate Where Prohibited
Do not allow the Danalock V3 unit to operate wherever wireless
radio communication use is prohibited or when doing so may
cause interference or danger as the Danalock V3 cannot be
turned off after installation.
Device Operation and human exposure to
electromagnetic fields
The Danalock V3 unit is a low power radio transmitter and
receiver. Periodically the Danalock V3 wakes up either due to
activity or by a timer. When it is ON, it receives and sends out
radio frequency (RF) signals for a short period of time.
Specific Human Absorption Ratio (SAR)
The Danalock V3 unit is not intended for handheld use or to be
worn on the body. A minimum separation of eight (8") inches
(20 cm) is to be maintained between the Danalock V3 and any
persons' body.
Pacemakers and other Medical Devices
If any other personal medical devices are used in the vicinity of
a Danalock V3 unit, consult the manufacturers of the medical
devices to determine if they are adequately shielded from
external RF energy. Physicians may be able to assist in obtaining
this information.
Interference
Like all wireless devices, the Danalock V3 may encounter
electrical interference that may affect its performance. The
Danalock V3 is tested and certified according to international
and European standards. The performance hereof ensures
correct operation in the presence of electromagnetic
interference and/or electrostatic discharge.
Category of use
The Danalock V3 is an electronic doorknob with wireless
interface for mounting on access doors.
Security for electrical functions
The Danalock V3 has an indoor led indications for operational
status but no sound alarms in case of a connected lock
malfunction.
Security for electrical manipulation
The Danalock V3 is tested compliance to the EMC requirement
laid out in the 2014/53/EU directive. The performance hereof
ensures correct operation in the presence of electromagnetic
interference and/or electrostatic discharge.
Children
The Danalock V3 series and its accessories are not used to solicit
data from or market to children
Fire doors
The Danalock is not approved for use with fire doors.
Water-Resistance
The Danalock is not water-resistant. The lock must therefore
be installed on the inside of the door where it is dry and not
subjected to either water streams or submersion. EN 14846
corrosion resistance classification grade=0.
Accessories and Batteries
The Danalock uses 4 x Panasonic CR123A or Duracell DL123A
lithium batteries (Intl. model: CR17345). Use only approved
accessories or batteries. Do not connect incompatible products.
There is risk of explosion or fire if an incorrect type replacement
battery contacts are shorted. Do not exceed the temperature
ranges or other environmental conditions specified by the
battery manufacturer. Dispose of used batteries according to
the instructions provided with the batteries.
Potentially Explosive Atmospheres
The Danalock cannot be turned off after installation, so any
building installed with Danalock etc. must not be located in an
area with a potentially explosive atmosphere and obey all signs
and instructions not to use Danalock in such areas. Sparks in