danalock V3 EURO Expert Install

Danalock V3 EURO Expert install for rosette doors

Tools needed

To mount the Danalock
you need a Philips
screwdriver and two
pliers or a wire cutter.
Contents of the
Adjustable
Danalock box
cylinder
you'll need for
the easy install
Rosette spacers
Tailpiece
adapter
Back plate Breakable screws

3. Adjust the new cylinder

Measure the back part of
the old cylinder from the
middle of the screwhole
and away (see illustration).
In the Danalock box
you'll find an adjustable
lock cylinder.
4. Just unscrew
the small screws
on both sides of
the part you want
to remove and pull
the cylinder apart.
5. Insert new brass
tube and spacer piece
Remove too big
+7
spacer piece
and brass tube
+32
32
6. Assemble the cylinder and
screw the tiny screws back in.
Rosette screw
and treaded tube
Small screwdriver
Cylinder
brass tubes
Back part
Measure from
center of screwhole
32
7
Please look at the size
guide to the right to find
the length for the spacer
piece and brass tube.
Parts involved on
your existing lock
Mortise plate
Lock screw
a
b

7. Size guide

When you remove one or
more parts of the cylinder
you'll have to exchange the
brass tube in the center with
another that fits the new
measurements.
here is the different
combinations.
Fits min. 50 mm
Fits min. 55 mm
Fits min. 60 mm
Fits min. 65 mm
The adjustable
cylinder as it is
in the box
32 space piece
Rosette plate
Cylinder

1. Remove the old door lock

Remove your current cylinder. Start
with removing the rosettes and the
screws on both sides of the door.
(a) Save the screw with the threaded
tube part for later use.
Remember to unscrew the lock-
screw in the mortise-plate on the
side of the door. (b)
cam
Insert your key and turn it so the
cam lines up with the body of the
cylinder and pull it out.(c)
c
a
Fits min. 35 mm
=
Fits min. 40 mm
=
7
+7
7 space piece
Fits min. 45 mm
=
10
+10
10 space piece
=
15
15 space piece
=
22
22 space piece
=
25
25 space piece
=
32
page 1/3
+15
+22
+25
+32