Pioneer PDP-5050SX Service Manual page 217

5
Installing the Plasma Display
Over 50 cm (19
Over 10cm
(3
inches )
Locating
• Avoid direct sunlight. Maintain adequate ventilation.
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
• If you place anything on the top of the Plasma Display it
will not receive enough ventilation and will not operate
properly.
• Allow enough space around the upper and back parts when
installing to ensure ventilation around the backside.
Using the optional PIONEER stand
For details on installation, refer to the instruction manual
supplied with the stand.
• This product may be used only with model PDK-TS10
stand. Use with other stands may result in instability
causing possible injury.
Using the optional PIONEER speakers
For details on installation, refer to the instruction
manual supplied with the speaker.
Operating Environment
Operating environment temperature and humidity: +0°C to
+40°C (+32°F to +104°F); less than 85% RH (cooling vents
not blocked)
Avoid installing at the following locations:
• Under direct exposure to sunlight
• Under strong artificial light
• In high humidity
• Poorly ventilated
5
6
inches)
PDP-5050SX
6
7
Preventing the Plasma Display from
Falling Over
After installing the stand, be sure to take special care to
ensure that the Plasma Display will not fall over.
Stabilizing on table or floor
Stabilize the Plasma Display as shown in the diagram using
screws that are available on the market.
• To stabilize the Plasma Display on a table or on the floor, use
screws that have a nominal diameter of 6 mm (1/4 inch) and that
are at least 20 mm (13/16 inch) long.
PDK-TS10
• A table or an area of the floor with adequate strength
should always be used to support the Plasma Display.
Failure to do so could result in personal injury and
physical damage.
• When installing the Plasma Display, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as earthquakes,
or of accidents.
• If you do not take these precautions, the Plasma Display
could fall down and cause injury.
• The screws, hooks, chains and other fittings that you use
to secure the Plasma Display to prevent it from
overturning will vary according to the composition and
thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks, chains and other
fittings after first inspecting the surface carefully to
determine its thickness and composition and after
consulting a professional installer if necessary.
7
8
A
B
Min. 20 mm
(13/16 inch)
C
D
E
F
217
8