Projector Management Using Snmp - Hitachi CP-EX3051WN User Manual-Network Manual

8.2 Projector Management using SNMP

The SNMP Simple Network Management Protocol) enables to manage the
projector information, which is a failure or warning status, from the computer on
the network.
NOTE
It is recommended that SNMP functions are executed by a network
administrator.
SNMP management software must be installed on the computer to monitor
the projector ia SNMP.
Standard MIB (MIB-2)
You can refer to the following items de ned in system group of Standard MI
MI -2).
Item
sysName
sys ocation
sysContact
Enhanced MIB
You can get con guration information by using Enhanced MI for projectors.
Enhanced MI for projectors can be downloaded from [Port Settings] page in
Projector Web Control.
Trap
When an error or warning occurs in the projector, a noti cation can be sent to the
speci ed address.
In addition to e-mail alert shown in 8.1 E-mail Alerts
noti cation can be sent.
Item
Cold Start
Authentication Failure
Projector name is set.
The information on where it is located. It has character string
set in sys ocation SNMP) in Projector Web Control - [Network
Settings] - [Common Setup].
The information on the administrator's contact information. It
has character string set in sysContact SNMP) in Projector
Web Control - [Network Settings] - [Common Setup].
When the projector is supplied with the power, it works as
below.
If the STAND Y MODE is set to the NORMA : the projector's
power status changes from "OFF" to "Standby state".
If the STAND Y MODE is set to the NETWORK WO ) or
SA IN : the projector's power status changes from "Standby
state" to "ON lamp is turned on)".
SETUP menu in the Operating
The SNMP access is detected from the in alid SNMP
community.
8. Other Functions
Description
88), the following
Description
uide).
91