Communication Setup; Communication Port - Hitachi CP-EX3051WN User Manual-Network Manual

7.2 Communication setup

To con gure the setup of the communication using NETWORK RID E for
the projector, use items in the COMMUNICATION menu. Open the menu of
the projector and select the OPTION - SER ICE - COMMUNICATION menu.
OPTION menu > SER ICE > COMMUNICATION in the Operating
1) In the COMMUNICATION TYPE menu, select NETWORK RID E
WIRE ESS or WIRED depending on the type of connection you use) for the
CONTROL port.
2) Using the SERIA SETTIN S menu, select the proper baud rate and parity
for the CONTROL port, according to the speci cation of the RS-232C port of
the connected de ice. Default settings are as follows.
Data length
3) Using the TRANSMISSION METHOD menu, set up the proper method for the
CONTROL port according to your use.
NOTE
Using the COMMUNICATION menu, set up the communication. Remember
that an unsuitable setup could cause malfunction of communication.
When either one of the NETWORK RID E settings is selected in the
COMMUNICATION TYPE menu, RS-232C commands cannot be recei ed from
the CONTROL port.

7.3 Communication port

For the NETWORK RID E function, send the data from the computer to the
projector with using the Network ridge Port con gured in the Port Settings of
web browser.
NOTE
It is set to 9717 by default.
Item
AUD RATE 19200bps
PARITY NONE
8 bit
Start bit 1 bit
Stop bit 1 bit
48)
Condition
xed)
xed)
xed)
7. Network Bridge Function
uide)
85