Pentair SOLARTOUCH 521592 Installation And User Manual page 17

Setting Pump Speeds (IntelliFlo
Setting the IntelliFlo/IntelliPro Variable Speed (VS) Pump speed for solar/cooling and
freeze protect mode is setup in the pump's "Ext. Ctrl" menu. Note: The IntelliFlo pump
must be in "Running Schedule" mode to communicate with the SolarTouch
Note: SolarTouch controller supports one IntelliFlo or IntelliPro pump assigned to pump
(*) Note: Older IntelliFlo/IntelliPro 4x160/VS-3050 pumps do
ADDRESS 1.
not have a control panel display and do not display "Ext Ctrl."
Changing default pump speeds in Ext. Ctrl. Program 2 (1500 RPM) or
Program 3 (2350) and Program (3110) default speed:
To change the default pump speeds for Program 2,3, or 4:
1. From the pump's control panel, press the MENU button.
Press Up or Down arrow button until "EXT. CTRL." is displayed.
2.
Press Select button.
3.
4. Press the Up/Down arrow button to select Program 2*. Enter the
desired RPM for solar heat/cooling. Note: If Nocturnal cooling is required
select Program 3**. Select Program 4*** for Solar Hold.
Press the Select button to change the current value.
5.
To change the value, press the Left and Right arrow buttons to select
6.
which digit to modify, then use the Up and Down arrow buttons to change
the selected digit.
When you are done, press the Enter button to save the changes. To
7.
cancel any changes, press the Escape button to exit edit mode without
saving.
(*) Program 2 (Assigned for solar heating or cooling only - See page 5-7).
(**) Program 3 (Assigned for freeze protect mode only - See page 8).
(***) Program 4 (Assigned for Solar Hold feature - Default pump speed is 3110 RPM)
Note: Set freeze protection RPM's the same as solar heating to ensure proper flow.
Adjusting IntelliFlo or IntelliPro Pump Preset Speeds
Be sure the pump is powered on and the green power LED is on. SolarTouch
controller supports one IntelliFlo or IntelliPro pump assigned to pump ADDRESS 1.
The IntelliFlo pump must be in "Running Schedules" mode to communicate with the
SolarTouch controller. Note: IntelliFlo VS+SVRS and IntelliFlo VF (Variable Flow)
programmable (up to 8 time clocks) is not recommended for use with solar
systems.
To adjust one of the four preset (default) pump speeds:
The following describes how to adjust IntelliFlo and IntelliPro pump speeds.
The pump models include: IntelliFlo & IntelliPro Variable Speed 8 Programmable
time clocks. IntelliFlo & IntellPro VS 3050 (also known as 4x160).
Press the desired speed button (1- 4) to select the preset pump speed.
1.
When the selected speed button is pressed, the LED is on. The pump
preset buttons and speeds are: Speed button #1, (750 RPM), #2, (1500
RPM), #3, (2350 RPM) and #4, (3110 RPM).
2. Press the Start button. The pump will ramp to the selected preset speed.
Adjusting the pump speed while the pump is running, Press the Up/Down
3.
button to increase or decrease the pump speed. To save the adjusted
speed, Press and hold down a Speed Button for three (3) seconds to
save speed to the button.
- See page 6 for more information).
SolarTouch
and IntelliPro
®
Solar Control System Installation and User's Guide
®
VS Pumps)
®
Controller.
®
13