Manual Mode; Rest To Factory Default Settings (Erase Eeprom) - Pentair SOLARTOUCH 521592 Installation And User Manual

Manual Mode

To access the Manual mode menu from the Advanced menu, press and hold the MENU
button for three (3) seconds. Manual mode is useful for system setup or service purposes.
Manual mode settings will override existing SolarTouch
exit the Manual mode menu all previous system settings will resume. Note: While in the
Manual mode menu, the system will stay in Manual Mode until you manually exit
back to the Advanced Menu. In Manual Mode the SolarTouch controller relays actuators,
single speed pump and IntelliFlo
available in the Advanced Menu. Any changes made to settings while in Manual Mode will
not affect previously saved settings.
The Manual Mode Menu settings are as follows:
Menu Item
Solar Booster Pump (single speed) On / Off
IntelliFlo* - Ext. Ctrl. Program 2, Ext. Ctrl. Program 3, and Ctrl. Program 4 (set at pump).
Pressure Cleaner Pump
Actuator
(*) "IntelliFlo" is displayed when an IntelliFlo or IntelliPro pump is connected and
communicating with the SolarTouch controller.
Note: For IntelliFlo/IntelliPro pumps SolarTouch Controller connections,
see page 19.
Each relay remains in the state it was in when entering Manual Mode until it is manually
changed. While in manual mode, each relay will stay in any state set by the user as long
as they stay in Manual Mode.
SolarTouch Controller Relays: When exiting Manual Mode, all relays are turned off, and
then set to the previously save settings.
Cleaning your pool: Turn SolarTouch controller OFF while manually vacuuming your
pool/spa. Press and hold the Enter button for three (3) seconds to disable and re-enable
the SolarTouch controller when done.
Reset to Factory Default Settings (Erase EEPROM)
The SolarTouch controller factory default setting can be reset from the Erase EEPROM
menu. To access the Erase EEPROM menu: Press and hold the Menu button >
Advanced Menu > Utility Menu > Erase EEPROM > Erase EEPROM? (No/Yes)
The default settings are as follows:
Function
Heating
Cooling
Freeze
Start Diff.
Stop Diff.
Target Heating
Target Cooling
Solar Override
Pump can be manually controlled. Manual Mode is only
®
Action
On / Off
On / Off
Setting
Enabled
Disabled
Disabled
6° F (-15.5 C°)
3° F (-16.6° C)
80° F (26° C)
90° F (32° C)
Disabled
SolarTouch
Controller settings. After you
®
Solar Control System Installation and User's Guide
®
9