Task Force Tips Masterstream Series Instructions For Installation, Operation And Maintenance page 2

Manual: Foam Aspirators
TASK FORCE TIPS LLC
MADE IN USA • TFT.COM
©Copyright Task Force Tips LLC 1998-2018
ER Nozzle Wiring Guide
©Copyright Task Force Tips LLC 1999-2020
SUPPORTING MATERIALS
The following documents contain supporting safety and operating
information pertaining to the equipment described in this manual.
LIA-025
TASK FORCE TIPS
ELECTRIC REMOTE NOZZLES
ELECTRIC REMOTE WIRING DIAGRAM
LESS ELABORATE WIRING
SYSTEMS MAY BE USED BY
ELIMINATING UPPER CONTROL
OR REMOTE CONTROL STATIONS
3701 INNOVATION WAY, VALPARAISO, IN 46383-9327
(800) 348-2686 (219) 462-6161 FAX (219) 464-7155
LIM-040 August 1, 2018 Rev05
LIM-040
1.0 To estimate elevation angle when vertical and horizontal distances to target are known:
2.0 To estimate maximum reach for a given elevation angle above 0°:
3.0 To estimate maximum height for a given elevation angle above 0°:
©Copyright Task Force Tips, Inc. 2009
SECTION 3.0
SECTION 4.0
Electrical Controls Installation and Operation
SECTION 4.1
Monitor Mounted
Operator Station
SECTION 4.2
Panel Mount
Operator Station
(Y4E-RP)
SECTION 4.3
Panel Mount With Display
Operator Station
(Y4E-RP-D)
SECTION 4.4
Tethered
Operator Station
(Y4E-CT-##)
SECTION 4.5
Tethered Operator Station
With Display
(Y4E-CT-##-D)
SECTION 4.6
Wireless
Operator Station
(YE-RF-##)
SECTION 4.7
Wireless Operator Station
With Display
(YE-RF-##-D)
SECTION 4.8
Joystick
Operator Station
(Y4E-JS)
©Copyright Task Force Tips LLC 2008-2019
2
NOZZLE TRAJECTORY
ELEVATION FACTORS
Reach Factor (compared to 30° elevation)
0.0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8
3.5
85°
75°
3.0
IF TARGET IS IN THIS REGION,
FLOW AND/OR PRESSURE MUST
2.5
60°
BE INCREASED.
2.0
45°
1.5
1.0
30°
0.5
15°
0.0
-0.5
-1.0
-1.5
- -45°
- -30°
- -15° - 0°
-2.0
Stream reach and height at non-optimal elevations can be estimated as a factor of the performance at the optimal 30° elevation.
Refer to LIM-030 and LIM-035 for effective stream trajectories of Task Force Tips Masterstream nozzles at 30° elevation.
This graph cannot be used to estimate maximum reach for elevation angles below 30°.
1.1 Find the maximum height and reach at 30° from the appropriate trajectory curve in LIM-030 or LIM-035.
1.2 Calculate the Height Factor by dividing the vertical distance to the target by maximum height from step 1.1.
1.3 Calculate the Reach Factor by dividing the horizontal distance to the target by maximum reach from step 1.1.
1.4 On the graph of nozzle trajectory elevation factors, plot the intersection of the Height Factor and Reach factor from steps 1.2 and 1.3. If this point lies
on or between the curves given, estimate the appropriate elevation angle. If this point lies within the shaded region of the graph, then a higher
pressure must be used to reach the target.
2.1 From the graph of nozzle trajectory elevation factors, choose the trajectory curve for the desired elevation angle.
2.2 Find the point where this trajectory curve intersects the height of discharge (zero height line).
2.3 Estimate the Reach Factor at this point using the scale across the top of the graph.
2.4 Multiply this Reach Factor by the reach at 30° elevation from the appropriate trajectory curve in LIM-030 or LIM-035.
3.1 From the graph of nozzle trajectory elevation factors, choose the trajectory curve for the desired elevation angle.
3.2 Find the maximum height on this trajectory curve.
3.3 Estimate the Height Factor at the maximum height using the scale on the left side of the graph.
3.4 Multiply this Height Factor by the height at 30° elevation from the appropriate trajectory curve in LIM-030 or LIM-035.
TASK FORCE TIPS, INC. 3701 Innovation Way, Valparaiso, IN 46383-9327 USA
800-348-2686 • 219-462-6161 • Fax 219-464-7155
MADE IN USA • www.tft.com
LTT-135
Nozzle Trajectory Elevation
Factors
MANUAL: Remote Control (RC)
Monitor Electrical Controls
Supplemental Instructions for use with RC Monitor Manual
INSTRUCTIONS FOR INSTALLATION, SAFE OPERATION AND MAINTENANCE
Understand manual before use. Operation of this device without understanding the manual and
DANGER
receiving proper training is a misuse of this equipment. Obtain safety information at www.tft.
com/serial-number
SECTION 4.9
Toggle Switch Monitor
Operator Station
(Y4E-TS)
SECTION 4.10
Monitor Communication
Interface Control
(Y4E-COMM)
SECTION 4.11
Monitor Position Display
(Y4E-DISP)
SECTION 4.12
Remote Auxiliary Function
Interface Control
(YE-REMAUX)
SECTION 4.13
Electric RC Monitor Aerial
Truck Installation
SECTION 4.14
Multiplex Interface Control (YE-CAN#)
SECTION 4.15
Ethernet Interface Control
SECTION 4.16
Electric Nozzle Actuator
SECTION 4.17
Valve Kits
(YE-VK-PH)
SECTION 5.0
Troubleshooting
TASK FORCE TIPS LLC 3701 Innovation Way, IN 46383-9327 USA
800-348-2686 • 219-462-6161 • Fax 219-464-7155
MADE IN USA • tft.com
LIY-500
Manual: Remote Control (RC)
Monitor Electrical Controls
LIM-030 November 16, 2020 Rev15
0.9 1.0 1.1
height of
discharge
or
LTT-135 July 28, 2009 Rev00
LIY-500 April 8, 2019 Rev14