Table of Contents
Advertisement
Analog Units
Power Switch
Speed Control and Display
Thermo Scientific
Section 5
Refer to Section 3 for control panel references.
1. Depress top portion of power switch (I) to turn on shaker.
2. Depress bottom portion of power switch (0) to turn off shaker.
Caution It is recommended that shaking action be started at a low speed in
order to check that all vessels are secure and that no spilling of contents
will occur.
1. Slowly rotate the knob on the solid-state speed control clockwise to
increase speed and counterclockwise to decrease speed. The markings
on the outside of the dial are for reference purposes only.
2. The speed control tachometer provides an analog readout of the actual
platform rotation speed up to a maximum of 400 rpm.
Time(r)
1. From the 12 o'clock off position, rotate timer knob counterclockwise
to the On position to initiate continuous operation.
2. For timed operation, rotate timer knob clockwise from 1 minute to 60
minutes. The markings on the side of the dial are in 5-minute
increments.
Note Shaker will not operate if the timer is in the Off position.
Operation
s
MaxQ 7000
5-1
Advertisement
Table of Contents
