Before First Use - Zanussi ZOB 365 User Manual

• Do not clean the glass door with abrasive cleaning
agents or metal scraper. Heat resistant surface of the
inner glass can break and shatter.
• When the door glass panels are damaged they be-
come weak and can break. You must replace them.
Contact the service centre.
• Be careful when you remove the door from the appli-
ance. The door is heavy!
• Do not clean catalytic enamel (if applicable).
Risk of fire
• Open the door carefully. The use of ingredients with
alcohol can cause a mixture of alcohol and air. There
is the risk of fire.
• Do not let sparks or open flames come near the ap-
pliance when you open the door.
• Do not put flammable products or items that are wet
with flammable products, and/or fusible objects
(made of plastic or aluminium) in, near or on the ap-
pliance.
Oven lamp
• Bulb lamps used in this appliance are special lamps
selected for household appliances use only. They

Before first use

Warning! Refer to "Safety information" chapter.
Initial Cleaning
• Remove all parts from the appliance.
• Clean the appliance before first use.
Caution! Do not use abrasive cleaning agents!
This can damage the surface. Refer to chapter
"Care and Cleaning".
Pre-heating
1. Set function
and maximum temperature.
2. Let the appliance operate without the food for ap-
proximately 1 hour.
cannot be used for the full or partial illumination of a
household room.
• If it becomes necessary to replace the lamp use one
of the same power and specifically designed for
household appliances only.
• Disconnect the appliance from the power supply be-
fore the replacement of the oven lamp. There is the
risk of electrical shock.
Service centre
• Only an approved engineer can repair or work on the
appliance. Contact an approved service centre.
• Use only original spare parts.
Disposal of the appliance
• To prevent the risk of physical injury or damage
– Disconnect the appliance from the power supply.
– Cut off the mains cable and discard it.
– Discard the door catch. This prevents children or
small animals from being closed inside of the ap-
pliance. There is the risk of suffocation.
3. Set function
and maximum temperature.
4. Let the appliance operate without the food for ap-
proximately 10 minutes.
5. Set function
and maximum temperature.
6. Let the appliance operate without the food for ap-
proximately 10 minutes.
This is to burn off the residue in the appliance. The ac-
cessories can become more hot than usually. When you
pre-heat the appliance for the first time, the appliance
can make an odour and smoke. This is the usual effect.
Make sure the airflow is sufficient.
17