Configure Dns; Configure Passwords Menu - Juniper Route Insight Manager Quick Start Manual

Configure DNS

This menu selection sets the Domain Name Service (DNS) parameters when the
DHCP server is disabled.
Table 15 on page 19 shows sample output.
Table 15: Configure DNS

Configure Passwords Menu

This option displays a submenu to configure passwords for different purposes.
Table 16: Configure Passwords Menu
The Configure Console Password option sets a password to protect access to the
serial port console. If a console password is set, a password prompt is printed upon
connecting to the serial console. By default, no password is set and so no prompt is
printed to ask for a password. If a user disconnects from the serial console without
quitting back to the password prompt, the console will remain logged in so the next
user to connect will have access without needing to give the password again.
Menu Selection
Output DHCP Enabled
Output DHCP Disabled
Menu Selection
Output
localhost>4
WARNING: DNS manual settings not supported while
using DHCP. You must disable DHCP before changing
DNS.
(The configuration utility will return you to the main
menu.)
DNS: (press <ENTER> to accept current setting)
Primary DNS (0.0.0.0) : 10.0.1.20
Secondary DNS (0.0.0.0) : 10.128.1.20
Are you sure you want to make this change [y/N]? y
Please wait while changes are being applied ...
localhost>5
1) Configure Console Password
2) Configure Master Access Password
3) Return to Main Menu
Configure DNS
19
Configure DNS