General Information - Napoleon Dynamic Heat Control Installation Manual

WARNING
!
• Dynamic Heat Control™ MUST be installed during the installation of the appliance BEFORE appliance venting and gas
are installed.
• Ensure the appliance is completely cool before starting installation.
• To avoid danger of suffocation keep the packaging bag away from babies and children. Do not use in cribs, bed, carriages,
or play pens. This bag is not a toy. Knot before throwing away.
You will need:
Installer:
• Ability to use combustible framing and fi nishing right up to the fi replace opening.
• High temperatures above the front of the fi replace opening are signifi cantly reduced eliminating potential degrading
to sensitive fi nish material (cracks or discoloration).
• No additional electrical, fans, ducts, or manifolds are required which keeps installation straightforward.
User:
• Heat is circulated more consistently throughout the living space increasing comfort in front of the fi replace.
• Increased "real world" effi ciency as heat is moved into the room rather than retained inside the enclosure.
• Complete fl exibility in selection of fi nish materials.
• Ability to place a TV, sound bar or artwork above the fi replace.
The Dynamic Heat Control™ system relies on an optimized fl ow of air both through the appliance and the enclosure.
As such the installation of the Dynamic Heat Control™ system requires certain technical considerations when com-
pared to traditional fi replaces. Specifi cally, the Dynamic Heat Control™ requires the enclosure to be ventilated and
requires the installer to ensure that a minimum air outlet opening area is provided to allow heat to escape and circulate
at a prescribed minimum height and position. This must be carefully adhered to in the planning and the installation to
ensure the appliance functions safely and to minimize installation time.
*
In most common installation confi gurations, some specifi c installations require special provisions.
See "minimum clearance to combustible enclosures" section for details. Ensure to strictly adhere to in-
structions.
**
Always check appliance manufacturers' recommendations to confi rm suitability and any special
environmental limitations. For valuable or antique items, always refer to expert preservation instructions as
some items require specifi cally controlled temperature and/or humidity.

1.0 general information

general information
Included in this kit
Bracket
Wire Harness
High Limit Switch
Dynamic Heat Control™ is a system for man-
aging the heat produced by the appliance at and
around the fi replace. The purpose of the Dynamic
Heat Control™ is to move the heat away from
the fi replace to allow it to circulate more effectively
within the living space. By installing the Dynamic
Heat Control™ both the installer and the user gain
considerable benefi ts, see the following;
*
**
EN
Defl ector
Screws
3
W415-2753 / A / 07.20.20