Table Of Contents - Napoleon Dynamic Heat Control Installation Manual

table of contents

EN
1.0 general information
2.0 installation planning
2.1 installation option 1 - open enclosure (enclosure stops short of the ceiling)
2.2 installation option 2 - front opening
2.3 installation option 3 - rear opening
2.4 installation option 4 - open enclosure with hard combustible valance
2.5 installation option 5 - side openings
3.0 appliance overview
4.0 Dynamic Heat Control™ installation
4.1 high limit switch installation
5.0 minimum framing dimensions
6.0 minimum clearance to combustible enclosures
7.0 rough framing - before appliance installation
8.0 finish framing - after appliance installation
9.0 finishing
9.1 enclosure design
9.2 optional trim fi nishing
10.0 minimum combustible mantel clearances
11.0 maximum protrusion
12.0 Dynamic Heat Control™ installation checklist
note:
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel
Ltd. reserves the right to change or modify any information within this manual at any time without
notice. Changes, other than editorial, are denoted by a vertical line in the margin.
WARNING:
!
known to the State of California to cause cancer, and chemicals including toluene, which are
known to the State of California to cause birth defects or other reproductive harm.
For more information, go to www.P65Warnings.ca.gov.
2
W415-2753 / A / 07.20.20
This product can expose you to chemicals including chromium, which are
3
4
5
5
6
7
8
9
10
13
15
16
17
18
20
21
22
23
24
25