Outlet Pressure Adjustments - Clarke SE Series Operating & Maintenance Instructions

OUTLET PRESSURE ADJUSTMENTS

PORTABLE COMPRESSORS
1. Pressure Adjusting Knob
2. Outlet Taps
3. Quick Fit Nuts
4. Pressure Gauge
To adjust outlet pressure:
To increase pressure - turn knob (1) clockwise. To
decrease pressure - turn knob (1)
anticlockwise.
Outlet taps
- slide knurled section (2) away
from body to open, push towards body to
close.
NOTE: Pressure Gauge (4). Pressure shown will differ by approximately 1 bar
depending on whether the outlets are open/closed.
STATIONARY COMPRESSORS
These machines are not supplied with the facility to adjust outlet pressure. A
comprehensive range of airline accessories is available from your local CLARKE
stockist.
OVERLOAD BUTTON
The electric motor is fitted with an automatic
overload detector which will stop the motor if
an overload is detected.
If this happens,
1. Switch off at the pressure switch (Push
knob down or turn switch).
• Allow the compressor to cool down for 5-
10 minutes.
2. Press the Reset button shown on the right.
3. Switch on pressure switch (lift knob or twist switch).
If the overload trips repeatedly, it may indicate a fault with the compressor, in this
case you should contact the Clarke service department (see page 13).
OTHER PRODUCTS WITHIN OUR RANGE In addition to Air Compressors from 3–80 cfm, we
offer a vast range of airtools and airline equipment. Please ask your local dealer for
details of our range or a copy of our Power Products Catalogue
8
Fig.6
Illustrative
purposes only
(may vary)