Spare Parts And Service - Clarke SE Series Operating & Maintenance Instructions

SYMPTOM
Condensation at outlet Piping installation incorrect.
points.
Electric Motor too hot:
maximum temperature Faults in electrical installation
90 C (194 F).
Machine running but
not pumping air into
receiver (10 HP and
above).

Spare Parts and Service

For spare parts and service, please contact your nearest dealer, or
Clarke International, on one of the following numbers.
PARTS & SERVICE TEL.: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
PARTS: parts@clarkeinternational.com
SERVICE:
PROBABLE CAUSES
Compressor taking in air
which is too warm.
Delivery temperature of air
from air receiver too high.
Operational voltage too low.
Cooling fins of electric motor
blocked by dirt.
Air exhausting from solenoid
after starter has changed from
star to delta.
or e-mail as follows:
service@clarkeinternational.com
Consult your local dealer.
Obtain better fresh-air
supply for compressor.
a) Use a larger air receiver.
b) Contact Clarke Service
Call an electrician.
Contact Clarke Service
Department
Clean cooling fins.
Check solenoid valve.
Contact Clarke Service
Department
13
REMEDY
Department.