Subscribe to Our Youtube Channel
Related Manuals for Clarke SSC1000G
Summary of Contents for Clarke SSC1000G
- Page 1 STRUT SPRING COMPRESSOR MODEL NO: SSC1000G PART NO: 7630030 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0718 ISS1...
-
Page 2: Technical Specifications
Oil grade VG15 hydraulic oil GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase. This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the purpose for which it was intended. -
Page 3: Safety Precautions
SAFETY PRECAUTIONS • Due to the weight of the product the help of an assistant may be required during installation. Secure the spring compressor to a firm level floor using suitable anchor bolts (not supplied). • Before starting work, check for signs of cracked welds, loose or missing bolts, damaged guards, or any structural damage. -
Page 4: Unpacking & Inventory
Ensure the spring compressor and its components suffered no damage during transit and that all components are present. Should any loss or damage become apparent, please contact your CLARKE dealer immediately. The following items should be present in the crate. -
Page 5: Tools Required
ASSEMBLY WARNING: DUE TO THE WEIGHT OF THE SPRING COMPRESSOR, LIFTING THE HELP OF AN ASSISTANT WILL BE HELPFUL DURING INSTALLATION. TOOLS REQUIRED • Wrench/socket set • Hex key ASSEMBLY PROCEDURE IMPORTANT: The spring compressor must be firmly secured to a firm and level floor using expansion bolts (not supplied). -
Page 6: Safety Guard Kit
4. Fit the lower support bracket of either the suspension leg or open yoke, to the column, engaging the bracket with the end of the hydraulic ram and securing with the set-screw. 5. Fit the corresponding upper bracket to the column, securing at the required height with the pins and R-clips. -
Page 7: Operation
2. Add the outer guards to the inner guards, locating them using the hinge pins supplied and lock with split pins. 3. Fit the closing latch to the guards. 4. Before operating the compressor, the safety chain should be wrapped around the inner and outer guards as shown, connecting the two chain ends with the snap hook. -
Page 8: Maintenance
It is recommended that a thorough annual inspection of the spring compressor, be made and that any defective parts be replaced with genuine Clarke parts. If the spring compressor appears to be damaged in any way, is found to be badly worn, or operates abnormally, it SHOULD BE REMOVED FROM SERVICE until the necessary repairs are made. -
Page 9: Troubleshooting
1. Depress the release valve pedal. 2. Pump the actuating pedal several full strokes to eliminate any air bubbles. Top up the hydraulic oil to the lower level of the filler plug with CLARKE hydraulic oil, Part No. 3050830. TROUBLESHOOTING... -
Page 10: Disposal Of Unwanted Materials
DISPOSAL OF UNWANTED MATERIALS One of the most damaging sources of environmental pollution is oil products. Never throw away used oil with domestic refuse or flush it down a sink or drain. Collect any oil in a leak proof container and take it to your local waste disposal site. Should hydraulic components become completely unserviceable and require disposal, draw off the oil into an approved container and dispose of the product and the oil according to local regulations. -
Page 11: Declaration Of Conformity
DESCRIPTION DESCRIPTION Bolt Upper Strut Support Base Support Circlip Main Frame Saddle Fixing Knob Screw Strut Clasp Hydraulic Ram Assembly Locating Pin Bolt Sleeve Actuating Pedal Lower Strut Holder Bolt Circlip Ram Base Spring Clasp Spring Clasp Bracket Release Foot Pedal Spring Clasp Holder Washer Washer...
Need help?
Do you have a question about the SSC1000G and is the answer not in the manual?
Questions and answers