Subscribe to Our Youtube Channel
Related Manuals for Clarke SPYDER 3
Summary of Contents for Clarke SPYDER 3
- Page 1 SPYDER 3 & 7 OIL FREE SPYDER 3 & 7 OIL FREE AIR COMPRESSOR AIR COMPRESSOR © 0503 OPERATION & MAINTENANCE INSTRUCTIONS Serial/Batch No: .......
-
Page 2: Specifications
2330021 Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the machine’s data plate ©... -
Page 3: Table Of Contents
For a professional looking finish paint must be thinned. If the manufacturers Thank you for purchasing this CLARKE SPYDER Oil Free Air Compressor, recommendations on thinning are not available, the following can be used as a which is designed for hobby and DIY use only. -
Page 4: Safety Precautions
Face masks will protect you against paint spray and/or fumes. PROBLEM CAUSE CORRECTION (Personal safety products can be obtained from your local Clarke dealer). Paint does not atomise Paint is too thick, air Add thinners. Increase air press. -
Page 5: Electrical Connections
PARTS DIAGRAM - RECEIVER AND COMPONENTS ELECTRICAL CONNECTIONS A. SPYDER 7 Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved 13 amp BS 1363 plug, or a suitably fused isolator switch. WARNING! THIS APPLIANCE MUST BE EARTHED IMPORTANT: The wires in the mains lead are coloured in accordance with the following code: Green &... -
Page 6: Operating Instructions
PARTS DIAGRAM - RECEIVER AND COMPONENTS OPERATION (Numbers in brackets refer to fig. 1 below) Before connecting your Spyder to the mains supply, check the following:- A. SPYDER 3 • The mains voltage is 230V. • The ON/OFF control knob (B) is in the OFF (inner) position. -
Page 7: Routine Maintenance
No. Description Part No. Switch ON the machine and try again. If the motor fails to start, after several Drain cock 3/8 FN022020000 attempts, consult your Clarke dealer. Vibration damper support FN020201000 Screw M5x15 FN014013042 Once the machine has started, turn ON the air supply to your air tool by opening the tap Tank 2 lt. - Page 8 • With a brush and soapy water wet all ‘screwed’ air connections • Any leaks will show through the formation of air bubbles. • Replace the piston (See your Clarke dealer) WARNING NEVER UNSCREW A CONNECTION WHILST THE AIR RECEIVER IS UNDER PRESSURE.
-
Page 9: Accessories
PARTS LIST - PUMP ACCESSORIES Description Part No. Your Clarke Spyder Oil Free Air Compressor can be used in conjunction with a range of optional accessories for inflating tyres, air brushing, stapling, blowing Housing FN116HP0001 and many other uses. For details contact your local accessory stockist. A complete... -
Page 10: Troubleshooting
CAUTION Do not attempt any repair or adjustment if you are uncertain as to how it should be done. If you have any queries, contact your local CLARKE Dealer. - 10 - - 11 -...
Need help?
Do you have a question about the SPYDER 3 and is the answer not in the manual?
Questions and answers