Related Manuals for Clarke SHHH5
Summary of Contents for Clarke SHHH5
- Page 1 SHHH AIR COMPRESSOR Model Nos. SHHH5/24 - SHHH5/50 - SHHH7/100 OPERATING & MAINTENANCE INSTRUCTIONS © 0306...
-
Page 2: Table Of Contents
Thank you for purchasing this CLARKE Shhh Air silent running air compressor Before attempting to operate the machine, please read this leaflet thoroughly and carefully follow the instructions given. In doing so you will ensure the safety of yourself and that of others around you, and you can also look forward to the compressor giving you long and satisfactory service. -
Page 3: Safety Precautions
DO NOT operate your compressor with any guards removed. Electrical or mechanical repairs should only be carried out by a qualified engineer. If problems occur, contact your Clarke dealer. Before carrying out any maintenance, ensure the pressure is expelled from the air receiver, and the machine is disconnected from the mains supply. -
Page 4: Electrical Connections
We recommend that this machine is connected to the mains supply via a Residual Current Device (RCD) If in any doubt, DO NOT attempt any connections or repairs yourself. Consult a qualified electrician, your Clarke dealer, 020 8556 4443 or telephone CLARKE International Service Dep’t on: or, e-mail : Service@clarkeinternational.com... -
Page 5: Preparation For Use
OPERATION Fig.1 Ensure the compressor is on level ground...do not allow it to run, positioned on an incline. Check that the mains voltage corresponds with that shown on the data label on the side of the compressor. Ensure that the ON/OFF switch, mounted on the Pressure Switch (shown in fig.1), is turned to the ‘0’... -
Page 6: Shutting Down
This operation is completely automatic and does not affect the spraying process in any way. However, should problems develop with the cut-in, cut out settings, please consult your Clarke dealer, or the Clarke Service Dep’t. -
Page 7: Fault Finding
FAULT FINDING PROBLEM PROBABLE CAUSE REMEDY The compressor Check the electrical Bad connections. will not start, or connections. stops and will not Clean and tighten as start again. necessary. Blown fuse Overload cutout switch has tripped. Compressor does Air receiver charged Open drain valve to expel air. -
Page 8: Maintenance
MAINTENANCE DAILY 1. Check the oil level before you start and top up if necessary - use Clarke Synthetic Air Compressor Oil ONLY, available from your Clarke dealer... Part No. 3050795 Fig.5 The oil level is checked by viewing the oil sight glass, shown arrowed in Fig. -
Page 9: Specifications
For details contact your local Clarke dealer. A complete kit - Model KIT 600, illustrated below, is available from your Clarke dealer, ideal for many applications..Please quote part number 3110150... -
Page 10: Declaration Of Conformity
PARTS & SERVICE For Spare Parts and Service,please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 PARTS & SERVICE FAX: 020 8558 3622 e-mail as follows: PARTS: Parts@clarkeinternational.com SERVICE: Service@clarkeinternational.com...