Replacement; Reversing Or Replacing The Clincher Points On The Clincher; Reversing Or Replacing The Driver Of The Stitching Head - Horizon Fitness SPF-10II Manual

4-3 Replacement

4-3-1 Reversing or Replacing the Clincher Points on the Clincher

If clincher point surface is worn or clincher
point are broken, stitch legs will not clinch
and/or be deformed. Reverse or replace
clincher points.
Remove clincher by the following procedure:
(1) Raise clincher and lift it out.
(2) Reverse or replace clincher points.
(3) When reassembling, push clincher down so
that the top lip of clincher slide will engage
the center of clincher.

4-3-2 Reversing or Replacing the Driver of the Stitching Head

A chipped driver is usually the result of
driving a stitch on top of another stitch. A
worn driver often causes deformed stitches or
fracturing at the corners of crown. The
driver is reversible for long use.
(1) Remove stitching head
(2) Swing swivel operating spring to the left.
(3) Remove swivel.
(4) Insert pointer object into the hole on driver
and press in on the high end of spring
which is located behind it.
(5) Slide driver down and out of head.
(6) Clean, reverse or replace driver.
(7) Reassemble.
35
4. Maintenance
Clincher
Point
Work
Face
Driver