York Sun Premier GZA1M Series Start-Up & Operation page 67

Table 26: Menus and Submenus (Continued)
Menu Submenu
Sensors >
Sensors
Summary
(Figure 27)
Unit
Commission
Standard
(Figure 28)
YORK
Parameters Displayed / Default
IAQSrc (Indoor Air Quality Source)
OAQ (Outdoor Air Quality Input)
SafetyCmdSrc (Safety Command
Source)
DAH (Discharge Air Humidity)
MAT (Mixed Air Temperature)
BldgPres (Building Static Pressure)
DA-P (Discharge Air Static Pressure)
UnitEn (Unit Enable, Default- Enable)
SenCal-Alarm (Sensor Calibration
Alarm) / Normal
Humidistat
Name (Unit Name)
Serial# (Unit Serial Number)
ModelName
Unit-S (Unit Status)
UnitEn (Unit Enable) / Enable
HdwrReset (Hardware Reset) / No
ResetLO (Reset Lockouts) / OFF
OccMode (Occupancy Mode) / Schedule
Tstat-Only (Thermostat Only Control
Enabled)
Clg-En (Cooling Mode Enabled for
Operation)
#ClgStgs (Number of Cooling Stages
Installed)
Htg-En (Heating Mode Enabled for
Operation)
#Htgstgs (Number Of Heating Stages
Installed)
Econ-En (Economizer Enabled For
Operation)
Econ-MinPos (Economizer Minimum
Position Setpoint)
LowSpeedFan-MinPos (Economizer
Damper Minimum Position Low Speed
Fan) / 25%
HighSpeedFan-MinPos (Economizer
Damper Minimum Position High Speed
Fan) / 5%
SZVAVEn (SZVAV Enabled, Set by
Factory)
Start-Up & Operation Guide | 5587001-YSG-A-520
Conditions for Parameters Displayed
Units / Range
Unreliable, Local Input, Network Sensor, High
Priority, BAS Override, Input Not Available
ppm
Unreliable, Local Input, Network Sensor, High
Priority, BAS Override, Input Not Available
%RH
deg F
iwg
iwg
Shutdown, Enable
Normal, Alarm
OFF, ON
Idle, SD Alarm, Purge Command, Start-Up
Wizard, Morning Warm-Up, Air Tempering,
Dehumidification, Heating, Cooling, Economizer,
Fan Only, Comfort Ventilation, Start-Up Delay,
Disabled, Updating Software
Shutdown, Enable
No, Yes
OFF, ON
Schedule, External
No, Yes
No, Yes
No, Yes
stages (0–8)
No, Yes
% (0–100)
% (0–100)
% (0–100)
OFF, ON
67