York Sun Premier GZA1M Series Start-Up & Operation page 88

5587001-YSG-A-520 | Start-Up & Operation Guide
Table 26: Menus and Submenus (Continued)
Menu Submenu
Humidity >
Setup
Details
(Figure 31)
Humidity >
Service
ERV
88
Parameters Displayed / Default
HGRUnoccHum-SP (HGRH Unoccupied
Humidity Setpoint)
SatisfiedDehum (Dehumidify In Satisfied)
Hum-En (Humidification Enabled)
Hum-SP (Humidification Setpoint)
UnoccHum-En (Humidify in Unoccupied)
DAH-Sp (Discharge Air Humidity
Setpoint)
SatisfiedHum (Humidify In Satisfied)
HumidistatMode
DehumEvapLowSp (Dehum Evap Low
Setpoint)
Cooling Discharge Air Temperature
Lower Setpoint
HGR-S (Hot Gas Reheat Status) / OFF-
Idle
StgClgCmd (Staged Cooling Command)
Evaporator Coil Temperature
(Evaporator Coil Temp)
OprEvapTempSp (Operational
Evaporator Temperature Setpoint)
Discharge Air Temperature
OprHGRTempSp (Operational HGRH
Temperature Setpoint)
OprZT (Operational Zone Temperature)
OprZH ((Operational Zone Humidity)
HGR (Hot Gas Reheat Command)
C1A (Compressor 1A Command) / OFF
C1B (Compressor 1B Command) / OFF
C2A (Compressor 2A Command) / OFF
C2B (Compressor 2B Command) / OFF
Modulating Compressor Output
RAH (Space Humidity RAH Input)
ZAH (Zone Humidity Input)
HGRB-C (Hot Gas Reheat Bleed Valve
Command) / Open
RAH-Alarm (Return Air Humidity Sensor
Alarm) / Normal
Humidistat
HRW-S (Heat Recovery Wheel Status)
SF-C (Supply Fan Command)
Econ-Free (Economizer Free Cooling
Available)
EAHR-T (Exhaust Air Heat Recovery
Temperature)
Conditions for Parameters Displayed
Units / Range
% (0–100)
False, True
Disable, Enable
%RH (0–100)
Disable, Enable
%RH (0–85)
False, True
None, Humidification, Dehumidification
deg F
deg F
OFF - Idle, ON-Normal Command, ON-Alternate
Operation Command, OFF-Disabled
%
deg F
deg F
deg F
deg F
deg F
%RH
%
OFF, ON
OFF, ON
OFF, ON
OFF, ON
% (0–100)
%RH
%RH
Close, Open
Normal, Alarm
OFF, ON
OFF, Max Cooling, Max Heating, Blocking
Protection, Heating Control, Heating Low Limit
OFF, ON
No, Yes
deg F
YORK