Table of Contents
Advertisement
5587001-YSG-A-520 | Start-Up & Operation Guide
Communication
The Applied Smart Equipment controller is a unified
platform for controllers in commercial unitary, chiller,
and air handling products manufactured by YORK.
This product line uses the Applied Smart Equipment
controller as the primary system control.
The control board allows flexibility for comfort control
input from:
• a wall thermostat
• thermistor sensors included with the unit
• a communicating NetSensor
• communicated sensor values when BAS integra-
tion is utilized
BACnet Integration Setup
LED Lights:
PWR FLT SA MOD EQ FC
FC BUS
Terminal Block
SHLD
COM
–
+
+
–
COM
PWR
SA BUS
Terminal Block
Modbus Terminal Block
Figure 39: Applied Smart Equipment Controller (Main Control Board)
94
BACnet IP Communication Card
EQ BUS Terminal Block
The unit ships with a USB drive inserted into the USB
port on the main control board, which allows back-up
and restoration of control parameters as well as con-
trol board firmware upgrades. This USB drive should
remain in the main control board. The controller has
BACnet MS/TP, Modbus, and N2 as the standard com-
munication protocols. An optional BACnet IP communi-
cation board is also available.
BACnet Testing Laboratories (BTL)
Certification
The controller supports the BACnet communication
protocol and is designed and certified by BACnet Test-
ing Laboratories (BTL) to meet the requirements of the
advanced application control profile.
USB Port
LED Lights:
ETH1 ETH2
End of Line (EOL) Switch
ON
OFF
LD27995
YORK
Advertisement
Table of Contents
