Table of Contents
Advertisement
4.5.1.2 IEEE 802.1Q VLAN
This function group individual ports into a small "Virtual" network of their own to be independent of the other ports. By
setting the VLAN Type with 802.1Q, IEEE 802.1Q tag-based VLAN is enabled. VLAN classification is the first step before
VLAN table lookup. The PoE Switch will check the VID value of the received packets and the VLAN table ingress / egress
rule, then forwards the packets to valid destination ports.
Select "802.1Q VLAN" and press "Apply" button, to enable the IEEE 802.1Q VLAN function then continue configure 16
802.1Q VLAN groups as your request. After setup completed, please press "Apply" to take effect. As shown in
4-29
and description on
Table 4-11
The page includes the following fields:
Object
VLAN Type
Figure 4-29 VLAN Group – 802.1Q VLAN screen
Description
There're two VLAN mode support – 802.1Q VLAN and Port-Based VLAN
• 802.1Q – Packets income will be tagged with VID as the PVID setting. All ports
on the switch belong to default VLAN (VID 1).
• Port-Based - Packets can only be broadcast among other members of the
same VLAN group. Note all unselected ports are treated as belonging to the
default system VLAN.
-52 -
User's Manual
Figure
Advertisement
Table of Contents
