Table of Contents
Advertisement
Before connect the other switches, workstation or Media Converter.
1.
Make sure both side of the SFP transceiver are with the same media type or WDM pair, for example: 100Base-FX to
100Base-FX, 100Base-BX20-U to 100Base-BX20-D.
2.
Check the fiber-optic cable type match the SFP transceiver model.
To connect to MFB-FX SFP transceiver, use the multi-mode fiber cable- with one side must be male duplex LC
connector type.
To connect to MFB-F20/F40/F60/FA20/FB20 SFP transceiver, use the single-mode fiber cable-with one side
must be male duplex LC connector type.
Connect the fiber cable
1.
Attach the duplex LC connector on the network cable into the SFP transceiver.
2.
Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a Media
Converter.
3.
Check the LNK/ACT LED of the SFP slot of the switch / converter. Ensure that the SFP transceiver is operating
correctly.
4.
Check the Link mode of the SFP port if the link failed. Co works with some fiber-NICs or Media Converters, set the Link
mode to "100 Force" is needed.
Figure 2-6 Plug-in the SFP transceiver
-22 -
User's Manual
Advertisement
Table of Contents
