S T R E N G T H E Q U I P M E N T
CABLE & BELT TENSIONING
TOOLS NEEDED
•
4 mm Allen socket
•
Large size pliers
AURA BELT TENSIONING
1.
Loosen bolts on the fold over clamp or barrel clamp.
2. Using your hand, pull any slack out of the belt, using a pliers on the cut end of the belt, pull to
remove the slack.
3. Tighten bolts following the instruction below.
Note: Three squares of extra belt must show on the opposite side of the clamp when tightening bolts.
For belting with a fold over clamp, add Red Vibra-Tite® Threadlocker to the four bolts and tighten to 5 N-m using a
torque wrench. The bolts should be tightened in a uniform pattern.
FIG. 1
For belting with a barrel clamp, add Red Vibra-Tite® Threadlocker to the two bolts and tighten to 30 N-m using a
torque wrench. The bolts should be tightened in a uniform pattern.
FIG. 2
Revis i on Date: April 2 020
25