Cxp Battery Charging - Matrix 7 Series Owner's Manual

GRO U P TRAININ G EQUIPM ENT

CXP BATTERY CHARGING

CXP (FC24)
Batteries will have approximately =>400cV (4.0VDC) when fully charged. When the battery level is at or below
350cV (3.5VDC), it should be removed and wall charged. The battery will also recharge when pedaling =>75 RPM.
CXP-02 (FC28)
Batteries will have approximately =>400cV (4.0VDC) when fully charged. When the battery level is at or below
350cV (3.5VDC), remove the service cover, connect the power cord to the charging cable on the LCB and wall
charge. The battery will also recharge when pedaling =>45 RPM.
Charging is recommended when:
• The console indicates that the battery is at or below 350cV
• The cycle has not been used for an extended period (~one month or longer)
• The situation dictates that the cycle must be useable while pedaling under 75 RPM (CXP) or 45 RPM
(CXP-02) for extended periods (not being used in a cycling class)
CHECKING BATTERY THROUGH CONSOLE
1. Press and hold the logo for 5–7 seconds.
2. When the number keypad pops up, type 2001 and press the check mark.
3. Scroll to and press Hardware.
4. Scroll to Raw LCB Data and look for Voltage.
a. This shows in cV. If below 350cV, the battery should be removed and wall charged.
5. Press the X in the upper right corner to exit.
The battery can be removed from the cycle and charged with a standard USB-micro cable. To charge multiple
batteries at once, a device similar to this
Matrix (Part# ZMS4009235).
Revis i on Date: April 2 020
5-port USB Charger can be used. You can also order a charger from
1 8