Table of Contents
Advertisement
150 High-voltage system ›
›
Disconnect the charging plug from the charging
socket.
›
Attach the protective cap to the charging socket.
›
Close the battery flap.
›
Where necessary, disconnect the charging cable
from the charger or from the mains socket.
If you leave the charging cable connected after
charging using alternating current (AC), the high-
voltage battery will not be discharged by electrical
consumers in the vehicle. These consumers are pow-
ered by the charger.
Initial charging and charging for longer service life
If the high-voltage battery is new or has not been
charged for a long time, the maximum state of
charge of the high-voltage battery may only be
reached after several charges. This is due to techni-
cal reasons and does not constitute a malfunction.
NOTICE
Danger of irreversible damage to the high-voltage
battery.
If the vehicle is not used for a long period of time,
▶
charge the high-voltage battery after a maximum
of four months.
Setting the charging process
Adjustments to applications
The following applications can be used, for example,
to set the delayed charge (departure time) or the
lower battery charge limit.
E-Manager
» page
61.
▶
ŠKODA Connect application (depending on Info-
▶
tainment)» page
85, or
» page
Prerequisites for starting time-delayed charging
✓ The vehicle is connected to a charger that sup-
ports time-delayed charging.
✓ Time-delayed charging is activated in the applica-
tion or in the E-Manager.
If, after the vehicle has been connected to the
charger, the state of charge is lower than the set
lower battery charge limit, the high-voltage battery
is charged immediately to the set charge limit.
Charging of high-voltage battery
114.
Change between time-delayed charging and in-
stant charging
Immediate charge button
A
Button for time-delayed charging
B
For a change to happen, the following pre-requisites
must be met.
✓ Vehicle unlocked.
✓ The vehicle is connected to a charger that sup-
ports time-delayed charging.
✓ Time-delayed charging has been activated, but
has not started yet.
Using the buttons
and
A
B
between time-delayed charging and instant charg-
ing. The symbol in the respective button is illumina-
ted.
Troubleshooting
Manual release of the charging plug from the
charging socket
If the charging plug remains locked in the charging
socket after charging is complete and cannot be un-
plugged, proceed as follows.
›
Check that the charging process is interrupted.
›
Open the engine compartment lid.
›
Remove the cover in the plastic part above the
charging socket.
›
Slide the screwdriver
A
opening
below the panel as far as it will go.
B
›
Pull the screwdriver in the direction of the arrow
to unlock the charging plug.
, it is possible to switch
from the tool kit into the
Advertisement
Table of Contents
