AJAX DoorProtect Plus User Manual page 10

Sensitivity
Ignore simple impact
Tilt sensor
Tilt
Tilt alarm delay
Always active
External Contact Type
Time before alarm, sec
(available for roller shutter motion detector only)
Impulses before alarm
(available for roller shutter motion detector only)
Alert with a siren if opening detected
Alert with a siren if an external contact is open
Alert with a siren if shock is detected
Alert with a siren if tilt is detected
Jeweller Signal Strength Test
Detection Zone Test
Attenuation test
User Guide
Unpair Device
Sensitivity level of the shock sensor
If active, the detector ignores single hit
If active, sensor will detect tilt
Selecting the normal angle of the sensor. Above
this limit, the sensor detects an alarm
The number of seconds from the moment the
sensor is tilted to the alarm
When turned on, the detector is always armed
external wired
Selecting the type of
detector
The time in seconds during which a given number
of impulses should be counted. This time is
counted after the first impulse of the detector.
Number of detector impulses required to raise an
alarm
HomeSiren
If active, and
activated when opening detected
If active, HomeSiren and StreetSiren are activated
during an external detector alarm
If active, HomeSiren and StreetSiren are activated
during a shock alarm
If active, HomeSiren and StreetSiren are activated
during a tilt alarm
Switches the detector to the signal strength test
mode
Switches the detector to the detection area test
Switches the detector to the signal fade test
mode (available in detectors with firmware
version 3.50 and later)
Opens the detector User Guide
Disconnects the detector from the hub and
deletes its settings
StreetSiren
are