Assa Abloy Corbin Russwin IN120 WiFi Installation Instructions Manual page 20

IN120 Mortise Lock
12. Installing Batteries
Before installing batteries for the first time:
Remove pull tab from its position beneath the coin cell by
pulling on tab in direction of arrows printed on tab (Fig. 18).
1. Place (6) "AA" alkaline batteries in the compartment, being
careful to align polarity properly.
2. After batteries are installed, there is a slight delay; then an
audible "beep" will sound and the lock motor will cycle.
13. Inside Cover Installation
1. Assemble cover by hooking top edge on
inside mounting plate.
2. Carefully press bottom of cover toward door
without pinching any wires.
3. Fully secure cover by tightening the security
screw at bottom of cover (Fig.19), utilizing
the security allen wrench.
Copyright © 2016 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Installation Instructions (Continued)
20
Fig. 19
Fig. 18