Assa Abloy Corbin Russwin IN120 WiFi Installation Instructions Manual page 18

IN120 Mortise Lock
10. Installation of Connectors
CAUTION - Do not touch or allow debris to enter connector contacts.
Secure the following connectors to their respective terminals (Fig. 16a, b):
A. Secure the 4-pin DPS connector. (Not required for ML202xx)
B. Secure the 10-pin lock body assembly connector.
C. Secure ground lug to #6-32 machine screw.
*NOTE: Optional 2-pin external 12-24VDC power connector.
IMPORTANT: Do not run wires through hole in plate (Fig. 16c, d) - this
will damage wires and the controller connector.
Route wires around flange, do not route wires through the
flange hole (Fig. 16c Detail).
Fig. 16c
3. Secure the 24-pin card reader connector (Fig. 16d).
Board-to-Board
Connector
Copyright © 2016 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Installation Instructions (Continued)
Reader
(24-pin)
Fig. 16d
18
DPS (4-pin)
Ground
Anchor
C
Fig. 16a
Fig. 16b
12-24VDC
Power*
A
B
Lock
Body
(10-pin)