Roll Bar Assembly; Assemble Retainer Pins; Assemble Top Loop; Install The Roll Bar - Briggs & Stratton Ferris IS5100Z Series Dealer Setup & Adjustment Instructions Manual

Roll Bar Assembly

Assemble Retainer Pins

1. Unpack the roll bar and hardware from the box.
2. Assemble the foam ring (A, Figure 6) onto the
retainer pin (B).
3. Loop the snap end of the lanyard (C) through the
retainer pin handle and snap together.
4. Install the lanyard anchor (D) onto the lanyard.
5. Install the clevis pin (E) onto the loop end of the
lanyard as shown in Figure 6.
Assemble the Top Loop
1. Install the plastic cap (B, Figure 7) into the end of the
top loop tube (A). Repeat for other end of tube.
2. Make sure the rubber stop (C) is properly seated
against the inside of the pivot mount. See Figure 7.

Install the Roll Bar

1. Make sure the roll bar sockets are clear of any
obstructions, wires, foreign objects, etc.
2. Install the roll bar upright tubes (A) into the sockets
as shown in Figure 8. Loosely install the 1/2-13 x 4"
bolts and hex side lock nuts (B, Figure 8).
NOTE: See Figure 9 for proper upright tube orientation.
IS5100Z Series - 33 HP Diesel
C
Snap End
B
Figure 6. Assemble the Retainer Pins
A. Foam Ring
B. Retainer Pin
C. Lanyard
D. Lanyard Anchor
E. Clevis Pin
A
Figure 7. Assemble the Top Loop
A. Top Loop Tube
B. Plastic Cap
C. Rubber Stop
A
B
Figure 8. Installing Roll Bar
A. Upright Tubes (LH Side Shown)
B. 1/2-13 x 4" Bolts & 1/2-13 Hex Side Lock Nuts
5
61" iCD Mower Deck
D
Loop End
E
A
B
C