Table of Contents
Advertisement
IS5100Z Series - 33 HP Diesel
61" iCD Mower Deck
Lubrication
Lubricate the unit at the locations shown in Figure 28
through 32.
Grease:
Use grease fittings when present. Disassemble parts
to apply grease to moving parts when grease fittings
are not installed.
Not all greases are compatible. Ferris Red Grease
(P/N 5022285) is recommended, automotive-type high-
temperature, lithium grease may be used when this is
not available.
Figure 28. Deck Lift Linkage Pivots
Figure 29. Deck Lubrication
Lubricating the Front Caster
Interval: Annually
1. Remove the 1/4-28 bolt (A, Figure 32) screwed into
the front caster and install a 1/4-28 grease fitting.
2. Grease the front caster.
3. Remove the 1/4-28 grease fitting and reinstall the
1/4-28 bolt.
4. Repeat the process for the other side of the machine.
Oil:
Generally, all moving metal parts should be oiled
where contact is made with other parts. Keep oil
and grease off belts and pulleys. Remember to wipe
fittings and surfaces clean both before and after
lubrication.
Figure 30. Control Handle Pivots & Seat Pivots
Figure 31. Gearbox Drive Idler Pivot
Figure 32. Front Caster & Wheel
A. 1/4-28 Bolt
14
A
Advertisement
Table of Contents
