Table of Contents
Advertisement
Adding Fuel
To add fuel:
1. Turn fuel shut off valves, located on the bottom of the
fuel tanks, to the "ON" position.
2. Remove the fuel cap (A, Figure 27).
3. Fill the tank to the bottom of the fill tube. This
will leave room in the tank for fuel expansion.
Refer to your engine manual for specific fuel
recommendations.
4. Install and hand tighten the fuel cap.
5. Repeat same process for opposite tank.
NOTE: The fuel tanks are tied together through a "tee"
in the supply lines. By filling only one tank, the level will
balance between the two tanks, effectively having 1/2
tank of fuel for each side.
IS5100Z Series - 33 HP Diesel
Figure 27. Fill Fuel Tank
A. Fuel Cap
13
61" iCD Mower Deck
A
Advertisement
Table of Contents
