Assembly Procedures - Briggs & Stratton TIGER Operation & Assembly Instructions

Safety Instructions
Maintaining the mower
• If the mower begins to vibrate abnormally, or if it strikes a foreign object - STOP the engine,
disconnect the spark plug lead and keep it away from the spark plug. Inspect the mower and blades
for any damage.
• Replace worn or faulty mufflers as they adversely affect engine performance and increase emissions.
• Store the mower in a well ventilated area, away from any naked flames such as those found in hot
water heaters.
Refuelling the mower
• Refuel the mower outdoors only.
• Do not smoke when refuelling the engine. Never add fuel or remove the fuel cap while the engine
is running or hot. If fuel is spilled, do not start the engine. Move the mower away from the area of
the spill. Do not create any source of ignition until fuel vapours have dissipated.
immediately.
• Store fuel in a cool place and in a container specifically designed for the purpose. In general, plastic
containers are unsuitable.
Handle Assembly Parts
Your lawnmower should include a kit with the following parts.
LOWER HANDLE
Attaching the Lower Handle

ASSEMBLY PROCEDURES

ZONE START
BRACKET
4 BOLTS
4 NUTS
1. Fit one of the bolts through the handle hole from the
inside and into the square hole in mounting bracket
of the base. Secure the nut but do not fully tighten at
this stage.
2. Repeat the same step for the remaining three
securing bolts.
3. Tighten all four nuts securely.
Clean any spills
2 HANDLE KNOBS
2 FLAT WASHERS
2 BOLTS
2 CABLE TIES
5