Table of Contents
Advertisement
IS5100Z Series - 33 HP Diesel
61" iCD Mower Deck
Suspension Adjustment
The shock assembly can be adjusted to vary the amount
of pre-load applied to the springs. This allows the
operator to maintain the ride height.
Use less pre-load for light weight operators. Use more
pre-load for heavy weight operators.
To adjust the spring pre-load:
1. Park machine on a flat, level surface. Disengage the
PTO, stop the engine and engage the parking brake.
2. See Figure 40. Using the supplied spanner wrench
(p/n 5022853), insert the tip of the wrench into
the notch in the pre-load adjuster. While holding
the wrench with both hands, turn CLOCKWISE to
decrease the pre-load, turn COUNTER-CLOCKWISE
to increase the pre-load. Make sure that for each
pair of shocks (A, B or C, Figure 40) that the left-
hand and right-hand are set to the same amount of
pre-load.
NOTE: Spanner wrench is located under the seat. Rear
tires must be removed to adjust the rear suspension.
FRONT
Figure 40. Adjust Spring Pre-Load
Briggs & Stratton Power Products Group, LLC.
Copyright © 2010 Briggs & Stratton Corporation
Milwaukee, WI, USA. All Rights Reserved.
The Ferris logo is a trademark of Briggs & Stratton
Corporation, Milwaukee, WI, USA.
A
WARNING
Use two hands when adjusting the shock springs.
This will prevent the wrench from slipping while
pressure is being applied.
Briggs & Stratton Power Products Group, LLC.
5375 North Main Street
Munnsville, NY 13409
(800) 933-6175
www.ferrisindustries.com
20
REAR
B
C
Advertisement
Table of Contents
