Configure The Device - Crestron DigitalMedia 3 Series Quick Start Manual

DMPS3-4K-350-C and DMPS3-4K-250-C Series
3-Series® DigitalMedia™ Presentation Systems
Determine the Address of the Device
The device can be addressed using the hostname or the IP address.
The default hostname is DMPS3- xxxxxxxx , where xxxxxxxx consists of the
last eight characters (excluding punctuation) of the MAC address.
For example, if the MAC address is 00:10:7F:08:09:AA:05, the default
hostname is DMPS3-0809AA05. The MAC address is labeled on the
shipping box and rear panel of the device.
The IP address is assigned using DHCP (Dynamic Host Configuration
Protocol), which is enabled by default. To set a static IP address, use
either of the following:
Crestron Toolbox™ software on a PC that connects to the device via
l
the Ethernet network or a USB connection to the COMPUTER port on
the front panel
NOTE: The Device Discovery Tool can be used to find the current IP
address.
The front panel LCD display menu
l

Configure the Device

Using the web interface, configure the device. To access the web interface,
open a web browser and enter either of the following:
hostname /setup ( hostname is the hostname of the device)
or
xxx.xxx.xxx.xxx /setup ( xxx.xxx.xxx.xxx is the IP address of the device)
The device also provides the built-in .AV Framework™ program, which
enables complete system control without requiring additional
programming. To access the .AV Framework configuration interface,
open a web browser and go to either of the following:
hostname :8008 ( hostname is the hostname of the device appended
by :8008)
or
xxx.xxx.xxx.xxx :8008 ( xxx.xxx.xxx.xxx is the IP address of the device
appended by :8008)
For more information, go to www.crestron.com/avframework.
Quick Start
5