Lever Brake Hose Installation - SRAM G2 RS Service Manual

L e v e r B r a k e H o s e I n s t a l l a t i o n
1 Slide the lever hose boot and compression nut away from the Slide the lever hose boot and compression nut away from the
compression fitting. compression fitting.
2 Cut the hose to install a new barb and compression fitting. Cut the hose to install a new barb and compression fitting.
You must install a new hose barb and compression fitting before
connecting the hose to the brake lever.
3 4 5 Apply DOT grease to the hose barb threads. Thread the hose barb into Apply DOT grease to the hose barb threads. Thread the hose barb into
the hose until it is flush with the end of the hose. the hose until it is flush with the end of the hose.
Do not overtighten the hose barb. Overtightening may cause damage
to the hose liner.
6 Thread the compression fitting over the hose barb, counter-clockwise, Thread the compression fitting over the hose barb, counter-clockwise,
until it is flush or slightly lower than the hose barb. until it is flush or slightly lower than the hose barb.
The compression fitting is reverse threaded. The compression fitting is reverse threaded.
Apply DOT grease to the outside of the compression fitting and the Apply DOT grease to the outside of the compression fitting and the
threads of the compression nut.Install the compression fitting and nut threads of the compression nut.Install the compression fitting and nut
into the lever. into the lever.
NOTI CE
NOTI CE
SRAM Hydraulic Hose Cutter
T8
DOT grease

Lever Brake Hose Installation

T8
33