Yamaha Tenere 700 2020 Service Manual page 14

Countdown tripmeter settings
To set the countdown tripmeter, select it by
pushing the top set button. When the units stop
flashing, push the top and bottom set buttons si-
multaneously until the first digit starts flashing. A
short press on the top button will increment the
unit from "9" to "0". Push the bottom set button to
select the next digit and set it following the same
procedure as the first digit. Push the bottom set
button to select the last digit and follow the same
procedure. Push the bottom set button to con-
firm the value.
TIP
• The maximum possible entering value is 900
km or 600 mi.
• The countdown tripmeter will start as soon as
you begin riding. When the countdown reach-
es "0" the display changes to the countdown
tripmeter "TRIP CD" and flashes 10 times.
• To reset the countdown tripmeter, select it and
while the digits flash, push the bottom set but-
ton until it is reset.
Instantaneous fuel consumption
1. Instantaneous fuel consumption display
This function calculates the fuel consumption
under current riding conditions.
The instantaneous fuel consumption display can
be set to either "km/L", "L/100 km" when using ki-
lometers.
To switch the fuel consumption units, push the
top set button until the measurement units
change. When using miles, the fuel consump-
tion unit is "MPG".
• "km/L": The distance that can be traveled on
1.0 L of fuel under the current riding conditions
is shown.
• "L/100 km": The amount of fuel necessary to
travel 100 km under the current riding condi-
tions is shown.
1
• "MPG": The distance that can be traveled on
1.0 Imp.gal of fuel under the current riding con-
ditions is shown.
To switch the instantaneous fuel consumption
settings, push and hold the left set button until
the display changes.
TIP
If traveling at speeds under 20 km/h (12 mi/h), "_
_._" is displayed.
Average fuel consumption
1. Average fuel consumption display
This display shows the average fuel consump-
tion since it was last reset.
The average fuel consumption can be set to ei-
ther "AVE_ _._ km/L", "AVE_ _._ L/100 km"
when using kilometers. To switch the fuel con-
sumption units, push the top set button until the
measurement units change. When using miles,
the fuel consumption is "AVE_ _._ MPG".
• "AVE_ _._ km/L": The average distance that
can be traveled on 1.0 L of fuel is shown.
• "AVE_ _._ L/100 km": The average amount of
fuel necessary to travel 100 km is shown.
• "AVE_ _._ MPG": The average distance that
can be traveled on 1.0 Imp.gal of fuel is shown.
To reset the average fuel consumption, select it
and while the digits flash push the bottom set
button until it is reset.
TIP
After resetting the average fuel consumption, "_
_._" will be shown until the vehicle has traveled
1 km (0.6 mi).
1-5
FEATURES
1